Showing posts with label radioactive. Show all posts
Showing posts with label radioactive. Show all posts

Tuesday, 31 January 2012

New Material to Remove Radioactive Gas from Spent Nuclear Fuel

This illustration of a metal-organic framework, or MOF, shows the metal center bound to organic molecules. Each MOF has a specific framework determined by the choice of metal and organic. Sandia chemists identified a MOF whose pore size and high surface area can separate and trap radioactive iodine molecules from a stream of spent nuclear fuel. (Credit: Image courtesy of Sandia National Laboratories)



Science Daily  — Research by a team of Sandia chemists could impact worldwide efforts to produce clean, safe nuclear energy and reduce radioactive waste.

The discovery could be applied to nuclear fuel reprocessing or to clean up nuclear reactor accidents. A characteristic of nuclear energy is that used fuel can be reprocessed to recover fissile materials and provide fresh fuel for nuclear power plants. Countries such as France, Russia and India are reprocessing spent fuel.The Sandia researchers have used metal-organic frameworks (MOFs) to capture and remove volatile radioactive gas from spent nuclear fuel. "This is one of the first attempts to use a MOF for iodine capture," said chemist Tina Nenoff of Sandia's Surface and Interface Sciences Department.
The process also reduces the volume of high-level wastes, a key concern of the Sandia researchers. "The goal is to find a methodology for highly selective separations that result in less waste being interred," Nenoff said.
Part of the challenge of reprocessing is to separate and isolate radioactive components that can't be burned as fuel. The Sandia team focused on removing iodine, whose isotopes have a half-life of 16 million years, from spent fuel.
They studied known materials, including silver-loaded zeolite, a crystalline, porous mineral with regular pore openings, high surface area and high mechanical, thermal and chemical stability. Various zeolite frameworks can trap and remove iodine from a stream of spent nuclear fuel, but need added silver to work well.
"Silver attracts iodine to form silver iodide," Nenoff said. "The zeolite holds the silver in its pores and then reacts with iodine to trap silver iodide."
But silver is expensive and poses environmental problems, so the team set out to engineer materials without silver that would work like zeolites but have higher capacity for the gas molecules. They explored why and how zeolite absorbs iodine, and used the critical components discovered to find the best MOF, named ZIF-8.
"We investigated the structural properties on how they work and translated that into new and improved materials," Nenoff said.
MOFs are crystalline, porous materials in which a metal center is bound to organic molecules by mild self-assembly chemical synthesis. The choice of metal and organic result in a very specific final framework.
The trick was to find a MOF highly selective for iodine. The Sandia researchers took the best elements of the zeolite Mordenite -- its pores, high surface area, stability and chemical absorption -- and identified a MOF that can separate one molecule, in this case iodine, from a stream of molecules. The MOF and pore-trapped iodine gas can then be incorporated into glass waste for long-term storage.
The Sandia team also fabricated MOFs, made of commercially available products, into durable pellets. The as-made MOF is a white powder with a tendency to blow around. The pellets provide a stable form to use without loss of surface area, Nenoff said.
Sandia has applied for a patent on the pellet technology, which could have commercial applications.
The Sandia researchers are part of the Off-Gas Sigma Team, which is led by Oak Ridge National Laboratory and studies waste-form capture of volatile gasses associated with nuclear fuel reprocessing. Other team members -- Pacific Northwest, Argonne and Idaho national laboratories -- are studying other volatile gases such as krypton, tritium and carbon.
The project began six years ago and the Sigma Team was formalized in 2009. It is funded by the U.S. Department of Energy Office of Nuclear Energy.
Sandia's iodine and MOFs research was featured in two recent articles in the Journal of the American Chemical Societyauthored by Nenoff and team members Dorina Sava, Mark Rodriguez, Jeffery Greathouse, Paul Crozier, Terry Garino, David Rademacher, Ben Cipiti, Haiqing Liu, Greg Halder, Peter Chupas, and Karena Chapman. Chupas, Halder and Chapman are from Argonne.
"The most important thing we did was introduce a new class of materials to nuclear waste remediation," said Sava, postdoctoral appointee on the project.
Nenoff said another recent paper in Industrial & Engineering Chemistry Research shows a one-step process that incorporates MOFs with iodine in a low-temperature, glass waste form. "We have a volatile off-gas capture using a MOF and we have a durable waste form," Nenoff said.
Nenoff and her colleagues are continuing their research into new and optimized MOFs for enhanced volatile gas separation and capture.
"We've shown that MOFs have the capacity to capture and, more importantly, retain many times more iodine than current materials technologies," said Argonne's Chapman.
Story Source:
The above story is reprinted from materials provided by DOE/Sandia National Laboratories, via News wise.
Note: Materials may be edited for content and length. For further information, please contact the source cited above.

Journal References:
  1. Karena W. Chapman, Dorina F. Sava, Gregory J. Halder, Peter J. Chupas, Tina M. Nenoff. Trapping Guests within a Nanoporous Metal–Organic Framework through Pressure-Induced Amorphization. Journal of the American Chemical Society, 2011; 133 (46): 18583 DOI:10.1021/ja2085096
  2. Dorina F. Sava, Mark A. Rodriguez, Karena W. Chapman, Peter J. Chupas, Jeffery A. Greathouse, Paul S. Crozier, Tina M. Nenoff. Capture of Volatile Iodine, a Gaseous Fission Product, by Zeolitic Imidazolate Framework-8.Journal of the American Chemical Society, 2011; 133 (32): 12398 DOI: 10.1021/ja204757x

Saturday, 11 June 2011

Simple method of dealing with harmful radioactive iodine discovered

ScienceDaily (May 24, 2011) — A novel way to immobilise radioactive forms of iodine using a microwave, has been discovered by an expert at the University of Sheffield. Iodine radioisotopes are produced by fission of uranium fuel in a nuclear reactor. Radioactive iodine is of concern because it is highly mobile in the environment and selective uptake by the thyroid gland can pose a significant cancer risk following long term exposure. Furthermore, iodine-129, which is a type of radioactive iodine, has an extremely long half life of 15.7 million years, so is one of the most significant long term hazards faced by the population due to its emission during the geological disposal of nuclear waste.

Professor Neil Hyatt, from the University´s Department of Materials Science and Engineering, has now found a way of locking up iodine radioisotopes in a durable, solid material suitable for ultimate disposal, like lead iodovanadinite(Pb5(VO4)3I). The research, which was published in the Journal of Nuclear Materials, demonstrates how his simple, inexpensive and rapid method can be done at atmospheric pressure.

Professor Hyatt and his team created a solid material for immobilisation of iodine with the formula Pb5(VO4)3I, by heating a mixture of lead iodide, lead oxide and vanadium oxide.

Previously, this has only been achieved using high pressure and a sealed container, because iodine is volatilised at high temperature. However, using the knowledge that vanadium is a good absorber of microwaves at 2.45 GHz -- the frequency used in domestic microwave ovens -- the team were able to heat the mixture of chemicals in a microwave oven to produce Pb5(VO4)3I in about three minutes.

The key to the method´s success is that Pb5(VO4)3I is a poor absorber of 2.45 GHz microwaves, so once this is formed, the sample cannot absorb microwaves, so the temperature does not get high enough for the iodine to volatilise.

Iodine-131 was the harmful gas emitted from the Fukushima power plant in Japan following the earthquake and tsunami last month, and was a significant contributor to the health effects from open-air atomic bomb testing in the 1950s, and was also emitted during the Chernobyl disaster. It is hoped the new research will reduce the public health impact associated with the release of radioactive iodine to the environment by providing a simple and inexpensive method of immobilisation in a solid material, which could be rapidly deployed in an accident scenario.

Professor Neil Hyatt, said: "In spent nuclear fuel, the iodine is not immobilised, so once the containment is breached it simply gets dispersed. At present, iodine-129 released by nuclear fuel reprocessing is discharged direct to the Irish Sea off the coast of Sellafield. Substantial quantities of this radioisotope were also released into the sea off the coast of Japan in the Fukushima incident. Our new method offers a way of safely and rapidly containing this radionuclide, reducing the potential long term impact on human health from discharge to the environment."

Story Source:

The above story is reprinted (with editorial adaptations by ScienceDaily staff) from materials provided by University of Sheffield.

Journal Reference:

M.C. Stennett, I.J. Pinnock, N.C. Hyatt. Rapid synthesis of Pb5(VO4)3I, for the immobilisation of iodine radioisotopes, by microwave dielectric heating. Journal of Nuclear Materials, 2011; DOI: 10.1016/j.jnucmat.2011.04.041

Note: If no author is given, the source is cited instead.

Disclaimer: This article is not intended to provide medical advice, diagnosis or treatment. Views expressed here do not necessarily reflect those of ScienceDaily or its staff.


View the original article here

Thursday, 9 June 2011

Simple method of dealing with harmful radioactive iodine discovered

ScienceDaily (May 24, 2011) — A novel way to immobilise radioactive forms of iodine using a microwave, has been discovered by an expert at the University of Sheffield. Iodine radioisotopes are produced by fission of uranium fuel in a nuclear reactor. Radioactive iodine is of concern because it is highly mobile in the environment and selective uptake by the thyroid gland can pose a significant cancer risk following long term exposure. Furthermore, iodine-129, which is a type of radioactive iodine, has an extremely long half life of 15.7 million years, so is one of the most significant long term hazards faced by the population due to its emission during the geological disposal of nuclear waste.

Professor Neil Hyatt, from the University´s Department of Materials Science and Engineering, has now found a way of locking up iodine radioisotopes in a durable, solid material suitable for ultimate disposal, like lead iodovanadinite(Pb5(VO4)3I). The research, which was published in the Journal of Nuclear Materials, demonstrates how his simple, inexpensive and rapid method can be done at atmospheric pressure.

Professor Hyatt and his team created a solid material for immobilisation of iodine with the formula Pb5(VO4)3I, by heating a mixture of lead iodide, lead oxide and vanadium oxide.

Previously, this has only been achieved using high pressure and a sealed container, because iodine is volatilised at high temperature. However, using the knowledge that vanadium is a good absorber of microwaves at 2.45 GHz -- the frequency used in domestic microwave ovens -- the team were able to heat the mixture of chemicals in a microwave oven to produce Pb5(VO4)3I in about three minutes.

The key to the method´s success is that Pb5(VO4)3I is a poor absorber of 2.45 GHz microwaves, so once this is formed, the sample cannot absorb microwaves, so the temperature does not get high enough for the iodine to volatilise.

Iodine-131 was the harmful gas emitted from the Fukushima power plant in Japan following the earthquake and tsunami last month, and was a significant contributor to the health effects from open-air atomic bomb testing in the 1950s, and was also emitted during the Chernobyl disaster. It is hoped the new research will reduce the public health impact associated with the release of radioactive iodine to the environment by providing a simple and inexpensive method of immobilisation in a solid material, which could be rapidly deployed in an accident scenario.

Professor Neil Hyatt, said: "In spent nuclear fuel, the iodine is not immobilised, so once the containment is breached it simply gets dispersed. At present, iodine-129 released by nuclear fuel reprocessing is discharged direct to the Irish Sea off the coast of Sellafield. Substantial quantities of this radioisotope were also released into the sea off the coast of Japan in the Fukushima incident. Our new method offers a way of safely and rapidly containing this radionuclide, reducing the potential long term impact on human health from discharge to the environment."

Story Source:

The above story is reprinted (with editorial adaptations by ScienceDaily staff) from materials provided by University of Sheffield.

Journal Reference:

M.C. Stennett, I.J. Pinnock, N.C. Hyatt. Rapid synthesis of Pb5(VO4)3I, for the immobilisation of iodine radioisotopes, by microwave dielectric heating. Journal of Nuclear Materials, 2011; DOI: 10.1016/j.jnucmat.2011.04.041

Note: If no author is given, the source is cited instead.

Disclaimer: This article is not intended to provide medical advice, diagnosis or treatment. Views expressed here do not necessarily reflect those of ScienceDaily or its staff.


View the original article here